GUNPRIMER : JOINT GUARD

Description

This is a special reinforcing tape to recover the looseness of joints and moving parts of the mechanical model.

In order to strengthen a previously loose joint, it was necessary to adjust it by sharpening it with adhesive and then adjusting it by scraping or replacing it, or gluing it to the joint while cutting a small strip by yourself.

This joint protection was developed so that even these loose joint parts can be easily maintained for a long time.

The reinforcing tape was cut into strips of six sizes to fit different trees. Additionally, it is a special soft tape with a non-slip coating on the surface, so it can reinforce joints without applying excessive stress to the parts.

In particular, the PS joint parts, often found in the latest kits, are easy to loosen, making them ideal for such joints and moving parts.

In addition, a total of 1 reinforcement strips are listed, so a single sheet can be used for several dozen mechanical models.

■ How to use
1. Select and paste a joint protector whose size covers about 2/3 of the loose parts.
2. Use one to three sheets depending on the degree of looseness if necessary.
3. When holding heavy parts, attach a small amount of instant adhesive to the side of the tape and dry it. (See video2 below)

Important point:
1. Be sure to remove grease and dust from the surface before applying.
2. All parts are ready for operation immediately after attaching the JOINT GUARD. However, for ball joints supporting heavy parts, it is recommended to start after 24 hours after applying a small amount of super glue.

Find Gunprimer products [ here ]